Preview

Science. Innovations. Technologies

Advanced search

Research the causes of annular manifestations during cementing of wells production casing

Abstract

Gas migration in the annulus or gas flows between the individual formations while casing of wells during pumping of the cement slurry is a very serious problem especially for wells in inhomogeneous formations and formations with abnormally high reservoir pressures. These phenomena can occur in the annulus of wells located both on land and at sea. The possibility of gas low from the reservoir into the annulus and migrate to the annulus is due to many reasons, some of them obvious and not in doubt and the other part based on assumptions either insufficient compelling interpretations of the conducted analyses of the production material or experimental studies to some extent may be questionable. The article discussed and studied the causes and nature of annulus manifestations in various mining and geological conditions, the results of researches of inluence of various factors on the tightness of the annular space and the inluence of geological, technical, mechanical, technological and physical-chemical factors on the origin of annular manifestations is analyzed. It is defined that we should recognize the geological factor in the formation of channels in the cement stone in the process of hardening as the main factor that inluenced the occurrence of complications. Based on the results of these studies the conformity of well construction technology is assessed, a scientiically based conclusion about the reasons of the annular manifestation that occurred in the operating well after completion of cementing the production casing is composed.

About the Authors

Rustam Ramizovich Gasumov
JSC SevKavNIPIgaz
Russian Federation


Vladimir Alekseevich Gridin
North-Caucasus Federal University
Russian Federation


Sergei Nikolaevich Ovcharov
North-Caucasus Federal University
Russian Federation


Eldar Ramozovich Gasumov
JSC SevKavNIPIgaz
Russian Federation


References

1. Гасумов Р.А. Особенности строительства глубоких скважин в осложненных горно-геологических условиях Предкавказья / Р.А. Гасумов, В.Г. Копченков, В.Т. Лукьянов, Н.Г. Федорова, С.Н. Овчаров // Наука. Инновации. Технологии. 2017. № 1. С. 123-140.

2. Сеид-Рза М.К. Технология бурения глубоких скважин в осложненных условиях. Баку: Азернешр, 1963. С. 338.

3. Антонов П.Л. Дальность и продолжительность диффузии газов из залежей в законтурные воды // Газовая промышленность. 1963. № 9. С. 1-6.

4. Малеванский В.Д. Открытые газовые фонтаны и борьба с ними. М.: Гостоптехиздат, 1963. С. 148.

5. Александров Б.Л. Определение и прогнозирование аномально высоких пластовых давлений геофизическими методами: обзор ВНИИОЭНГ М.: ВНИИОЭНГ, 1973. 80 с.

6. Гасумов Р.А. Геологические факторы, влияющие на качество крепления скважин (на примере конкретной скважины Прибрежной группы месторождений). // Геология, геофизика и разработка нефтяных и газовых месторождений. 2014. № 12. С. 48-53.

7. Гасумов Р.А. К вопросу о механизме возникновения флюидо-проявлений при цементировании скважин / Р.А. Гасумов, К.М Тагиров, Ю.И. Петраков // Сб. научн. статей: Строительство газовых и газоконденсатных скважин. М.: ВНИИгаз, 1992. С. 73-­76.

8. Боннет А., Пафитис Д. Миграция газа - взгляд в глубь проблемы: нефтегазовое обозрение / А. Боннет, Д. Пафитис // Шлюм-берже, 1998. С. 18-33.

9. Перейма А.А. Образование флюидопроводящих каналов в зацементированном пространстве скважин и основные пути его предотвращения / А.А. Перейма, Ю.К. Димитриади, Ю.С. Минченко // Газовая промышленность. 2011. № 7. С. 88-92.

10. Гасумов Р.А. Предупреждение заколонных флюидопроявлений при строительстве и капитальном ремонте скважин: автореф. дис.. канд. техн. наук / Ставрополь, 1994.


Review

For citations:


Gasumov R.R., Gridin V.A., Ovcharov S.N., Gasumov E.R. Research the causes of annular manifestations during cementing of wells production casing. Science. Innovations. Technologies. 2017;(4):125-136. (In Russ.)

Views: 70


Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 License.


ISSN 2308-4758 (Print)